Class Six and Seven

Task: Cut our own PCB board. And then we can make the Shanghaino.

I got the picture of the circut from Eagle.

   

Then, I went to use the SRM-20 to cut my board.

   

At beginning, I used the software called ClickMILL to make the surface flat.

   

Then I set the beginning point. Set x0, y0 and z0. After cutting, my PCB board was done.I used the electric iron and solder wire to stick the component on the PCB board.

   

   

But when I decided to upload my program to test whether the PCB board could work, it failed.